onelinkmore U.FL to N Male 4-Hole Flange Pigtail Cable 10cm 2-Pack — RG178 IPX MHF1 50 Ohm Panel Mount for Meshtastic Node Enclosure, LoRaWAN DIY Build, Custom IoT Gateway, MIMO Antenna

Cable type:RG178 coaxial cable； Cable length:10cm； Impedance: 50 Ohm； VSWR: <1.5:1； Frequency Range: DC to 6 GHz； Operating Temperature:-40°С ~ +85°С； Storage Temperature: -40°С ~ +85°С； Connector Polarity: Standard； Mount Method 1:4 Hole Flange Panel.

• 4-HOLE FLANGE PANEL MOUNT N MALE — BUILT FOR CUSTOM ENCLOSURE BUILDS: The N Male 4-hole square flange mounts flush to an enclosure wall using four M3 screws — creating a permanent, non-rotating panel feedthrough. Internal U.FL connects to your LoRa module (Heltec V3, RAK4631, LilyGO T-Beam) or WiFi/LTE board; external N Male accepts any N Female antenna connector. Eliminates bulkhead drilling for loose connectors — the four-screw flange distributes cable pull force across the panel.
• ⚠️ U.FL (MHF1) NOT MHF4 — AND N MALE FACES OUTWARD: U.FL (IPX/MHF1) snap-on end connects to your board's 2mm U.FL port — compatible with Heltec V3, LilyGO T-Beam, RAK WisBlock, ESP32 U.FL variants, and Mini PCIe cards. N Male flange end mounts on the enclosure exterior — your external antenna must have an N Female connector. If your antenna has N Male, you need N Female flange version instead. Check both board connector and antenna connector before ordering.
• RG178 10CM — RIGHT LENGTH FOR COMPACT NODE ENCLOSURES: 10cm routes cleanly from a centrally-mounted LoRa or WiFi module to an enclosure side wall without excess slack. RG178 1.9mm diameter fits through standard panel cutouts and bends around PCB components without kinking. Gold-plated U.FL contact, PTFE dielectric, 50 Ohm, VSWR ≤1.30, DC to 6GHz. Covers 915MHz LoRaWAN/Meshtastic, 2.4GHz WiFi/Bluetooth, and 5GHz WiFi frequencies.
• MESHTASTIC AND LORAWWAN NODE ENCLOSURE STANDARD FEEDTHROUGH: Purpose-built for the DIY RF community building weatherproof Meshtastic repeater nodes, solar-powered LoRaWAN gateways, and custom IoT sensor enclosures. The 4-hole flange provides a professional panel feedthrough that IP-rated enclosures (Hammond, Polycase, Bud Industries) accept without modification — far more secure than push-fit bulkhead connectors under antenna vibration and cable tension.
• 2-PACK FOR MIMO AND DUAL-ANTENNA BUILDS: MIMO cellular routers and dual-antenna LoRa builds need two feedthroughs simultaneously. This 2-pack equips both antenna ports in one purchase. Compatible with T-Mobile Home Internet gateway antenna modification projects (SMA-port models requiring N Female external antenna), RAK WisGate LoRaWAN gateways with U.FL internal ports, and any DIY enclosure requiring dual N Male panel feedthroughs.